Vega VEGAFLEX 81 Operating Instructions Manual

Also see for VEGAFLEX 81: Mounting instructions Operating instructions Quick setup guide Operating instructions Operating instructions

Contents

Vega VEGAFLEX 81 Operating Instructions Manual Manual pdf 2 page image

2Quick startVEGAFLEX 81 • 4 … 20 mA/HART two-wire41824-EN-130612Quick startThe quick start procedure enables a quick setup with many applica-tions. You can find further information in the respective chapters of theoperating instructions manual.1. Distance from the metallic vessel wall > 300 mm. Distance fromnon-metallic vessel wall > 500 mm. The probe must not touch anyinstallations or the vessel wall.2. In non-metallic vessels, place a metal sheet beneath the processfitting.1 2Fig. 1: Installation in non-metallic vessel1 Flange2 Metal sheet3. If necessary, fasten probe end.For further information see chapter "Mounting".1. Make sure that the power supply corresponds to the specifica-tions on the type label.2. Connect the instrument according to the following illustration51 2+( ) (-) 6 7 84...20mA2341Fig. 2: Electronics and connection compartment, single chamber housing1 Voltage supply, signal output2 For display and adjustment module or interface adapter3 For external display and adjustment unit4 Ground terminal for connection of the cable screenSee also chapter "Connecting to power supply"For standard applications we recommend selecting the "Quick setup"in the display and adjustment module.MountingElectrical connectionSet parameters