Vega VEGAPULS 63 Operating Instructions Manual

Also see for VEGAPULS 61: Operating instructions Quick setup guide Operating instructions Operating instructions Operating instructions

Vega VEGAPULS 63 Operating Instructions Manual Manual pdf 10 page image

103 Product descriptionVEGAPULS 63 • HART and accumulator pack40794-EN-140922hence to the level. The determined level is converted into an appropri-ate output signal and outputted as measured value.The instrument is powered via an integrated accumulator. This allowsoperation of the instrument independently of the mains or a controlsystem. To achieve a longer battery lifetime, the instrument is presetto HART multidrop. This puts a load of only 4 mA current on the ac-cumulator.3.3 Packaging, transport and storageYour instrument was protected by packaging during transport. Itscapacity to handle normal loads during transport is assured by a testbased on ISO 4180.The packaging of standard instruments consists of environment-friendly, recyclable cardboard. For special versions, PE foam or PEfoil is also used. Dispose of the packaging material via specialisedrecycling companies.Transport must be carried out in due consideration of the notes on thetransport packaging. Nonobservance of these instructions can causedamage to the device.The delivery must be checked for completeness and possible transitdamage immediately at receipt. Ascertained transit damage or con-cealed defects must be appropriately dealt with.Up to the time of installation, the packages must be left closed andstored according to the orientation and storage markings on theoutside.Unless otherwise indicated, the packages must be stored only underthe following conditions:• Not in the open• Dry and dust free• Not exposed to corrosive media• Protected against solar radiation• Avoiding mechanical shock and vibration• Storage and transport temperature see chapter "Supplement -Technical data - Ambient conditions"• Relative humidity 20 … 85 %3.4 Accessories and replacement partsThe display and adjustment module PLICSCOM is used for measuredvalue indication, adjustment and diagnosis. It can be inserted into thesensor or the external display and adjustment unit and removed atany time.You can find further information in the operating instructions "Displayand adjustment module PLICSCOM" (Document-ID 27835).Voltage supplyPackagingTransportTransport inspectionStorageStorage and transporttemperaturePLICSCOM