72 Product descriptionVEGAPULS SR 68 • Modbus and Levelmaster protocol47164-EN-180226This operating instructions manual applies to the following instrumentversions:• Hardware from 2.1.0• Software from 4.5.1Scope of this operatinginstructions manual

For your safety

EU conformity

Environmental instructions

Product description

Mounting

Mounting preparations

Mounting instructions

Connecting to power supply and bus system

Wiring plan

Set up the sensor with the display and adjustment module

Menu overview

Supplement

Information

Vega VEGAPULS SR 68 Quick Setup Manual

Authorised personnel

CE conformity

Radio license for USA/Canada

Configuration

Mounting 3.1 Mounting preparations - Parabolic antenna

Connecting to power supply 4.1 Connecting

Wiring plan, single chamber housing

Set up with the display and adjustment module 5.1 Insert display and adjustment module

Parameter adjustment

Supplement 6.1 Technical data

VEGAPULS SR 68

Measuring principle

Type overview

Instrument selection

Selection criteria

Housing overview

Electronics - 4 ... 20 mA/HART - two-wire

Electronics - 4 ... 20 mA/HART - four-wire

Electronics - Profibus PA

Electronics - Foundation Fieldbus

Electronics - Modbus, Levelmaster protocol

Operation

Dimensions

operating instructions

Function

Structure

Principle of operation

Accessories and replacement parts

General instructions

Mounting strap

Instructions for installation

Preparing the connection

Connect

Wiring plan with double chamber housing Ex d

Wiring plan - version IP 66/IP 68, 1 bar

Insert indicating and adjustment module

Adjustment system

Saving the parameter adjustment data

Connect the PC

Parameter adjustment with PACTware

DD adjustment programs

Maintaining

Asset Management function

Remove interferences

Exchanging the electronics module

How to proceed in case of repair

Dismounting steps

Supplement 11.1 Technical data

symbols used

for your safety

Radio license for USA

product description

principle of operation

Mounting 4.1 General instructions

Mounting preparations - Parabolic antenna

Connecting to power supply 5.1 Preparing the connection

Connecting

Wiring plan, double chamber housing

Double chamber housing with VEGADIS-Adapter

Switch-on phase

Set up with the display and adjustment module 6.1 Insert display and adjustment module

Measured value indication - Selection of national language

Saving the parameterisation data

Setup with PACTware 7.1 Connect the PC

Set up with other systems 8.1 DD adjustment programs

Maintenance

Rectify faults

software update

technical data

Industrial property rights

quick start

For your safety 2.1 Authorised personnel

Product description 3.1 Configuration

Mounting preparations - Horn antenna

Wiring plan, double chamber housing Ex d

Software update

Technical data

ambient conditions

Connection

Connecting the PC

Error messages according to NE 107

Fault rectiﬁcation

Packaging, transport and storage

Connecting to power supply and bus system 5.1 Preparing the connection

Double chamber housing with DIS-ADAPT

Set up the sensor with the display and adjustment module 6.1 Adjustment volume

Setting up sensor and Modbus interface with PACTware 7.1 Connect the PC

Diagnosis, asset management and service 8.1 Maintenance

Dismounting 9.1 Dismounting steps

Basics Modbus

Modbus register

Modbus RTU commands

Levelmaster commands

error codes

Configuration of typical Modbus hosts


Contents Table Of Contents For your safety EU conformity Environmental instructions Product description Mounting Mounting preparations Mounting instructions Connecting to power supply and bus system Wiring plan Set up the sensor with the display and adjustment module Menu overview Supplement Information	72 Product descriptionVEGAPULS SR 68 • Modbus and Levelmaster protocol47164-EN-180226This operating instructions manual applies to the following instrumentversions:• Hardware from 2.1.0• Software from 4.5.1Scope of this operatinginstructions manual Previous Next / 24