Vendors Exchange VE CONNECT User Manual
                           | |
| 2120 |Step 3 - Press 8, 8, 8, 6, 6 in sequence. The current drop sensor mode will showon the blue LCD screen.Step 4 - Press the desired mode, (00, 01, 02, 03, 04, or 05) and * to confirm.Step 5 - Press 4, 4 in sequence to exit.To manually set or change the UCB™ drop sensor configuration to mode 00 forDixie Narco® 501E, follow these steps:Step 1 - Open the door and locate the UCB™ and keypad.Step 2 - Press the “Mode” button on the UCB™ harness board located in thecorner of the board.Step 3 - Press 8, 8, 8, 6, 6 in sequence.The current drop sensor mode willshow on the blue LCD screen.Step 4 - Press the desired mode, (00,01, 02, 03, 04, or 05) and * to confirm.Step 5 - Press 4, 4 in sequence to exit.Single vend mode to NOThe firmware version and configuration of single vend mode must be correctfor proper VE CONNECT™ function.To check the single vend status follow these steps:Step 1 - Open the door and locate the UCB™and keypad.Step 2 - Press the “Mode” button on the UCB™ harnessboard located in the corner of the board.Step 3 - Press 8, 8, 8, *, 8, 7, 0, 0, *, 8, 8 in sequence. The current single vendmode YES or NO will be displayed.Step 4 - Press 5, * to change to NO if needed.Step 5 - Press 4, 4 in sequence to exit.Homing Motor to NO (Dixie Narco®501E only)Homing motor must be set to NO if you are operating a Dixie Narco®501EFollow these steps to set the motor homing NO:Step 1 - Open the door and locate the UCB™ and keypad.Step 2 - Press the “Mode” button on the UCB™ harness board located in theupper right hand corner of the UCB™.Step 3 - Press 8, 8, 8, 6, 8, 1, *, 4, 4 in sequence. Motor Homing is now set to NO.Setting TemperatureIf you have a refrigerated unit with a temperature sensor connected to theUCB™ and need to adjust the temperature settings outside of default, it canbe changed through the Advanced settings tab on the UCB™. See the UCB™programming flow chart for details.Clear Sold OutWhen the UCB™ detects that a particular product has failed to vend (dropsensor is not triggered even after reattempt), the item will display “Sold Out”on the user interface. A route person must inform the system that the tray hasbeen restocked or the “Sold Out” icon will remain and the product will notvend. Pressing the “Clear Sold Out” button on the Operator Menu will clear allthe sold out products.Note that a single item that is in multiple slots (a best seller, for example), willnot be marked as “Sold Out” if there is additional product available in alternatetrays. Single vend must be set to NO on the UCB™ for this feature to work. Forfurther information about single vend, see the section in this manual detailingUCB™ settings, or refer to the UCB™ Setup Guide.System InformationThe primary use of system information is to determine if you have an IP addressand that your internet connection is functioning.MODEButton |
Related manuals for Vendors Exchange VE CONNECT
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine