Vendors Exchange VE CONNECT User Manual
                           | |
| 2726 |Step 4 - The motor will vend, but product will not fall because you haveremoved the product. Watch/listen for the motor to make attempts to drop theproduct. If in Mode 4, it will make 1 full rotation. The product will be marked asSold Out on the user interface. The drop sensor is working.Tip: There is a red LED on the drop sensor that goes off when youwave your hand in front of it.Test Motors through the UCB™Follow these steps to test the motors using the keypad:With the door open press the "MODE" button on the harness board. Thedisplay shows “ACCESS CODE”.Press "8" until the display reads"SERVICE." Press "6" and the displayshows MOTOR TEST. Press "6" againand the display shows "MOTOR TEST:NO." Press any key to toggle between“NO” and “YES”. Press "*" and thedisplay returns to "MOTOR TEST. "To test vend motors choose “YES”,press "*" then press "4" until the display returns to "SELECT." All selections in themachine are now in test vend mode until the door switch is pressed. To testmotors, type the tray locations for each. For example with the AP 113, press“100”, then “110” or “120” depending on tray configuration. Repeat this processfor all tray locations to confirm the motors are functioning properly.Drop sensor ismounted on sidesof vend bucketDrop sensor ismounted on sidesof vend bucket5 Operating EquipmentRestockingRestocking the machine with VE CONNECT™ is no different than restocking atraditional vending machine, with the exception that if you make changes tothe product tray location you need to update the software according to thenew configuration. Also, any items that are “SOLD OUT” need to be refilled andthe route personnel must press “Clear Sold Out” from the Operator Menu.DEXDEX data is stored locally and can be accessed through the standard DEX jackincluded with the UCB™ and REVISION™ Door. For more information on auditdata, please refer to the UCB™ setup guide.Care and MaintenanceFollow the OEM owner’s documentation for cleaning and maintenanceinstructions specific to the associated vending machine. For VE CONNECT™specific care, please consider the following guides.DEX jack onREVISION™ Doorfor an AP 113MODEButton |
Related manuals for Vendors Exchange VE CONNECT
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine