WAGNER GM 1-350 Operating Manual

Also see for PROTEC GM 1-350: Translation of the original operating manual

19GM 1-350/530B_5054B_5303OPERATING MANUALVERSION 02/2015 ORDER NUMBER DOC23493697.3.5 ELIMINATE NOZZLE CLOGGING1. Relieve the pressure on the spray gun and product pressure generator in accordance with Chapter 7.3.2.2. Secure the spray gun with the locking device.3. Rotate the reversing nozzle 180° so that its tip is pointing opposite the direction of spray.Attention: when rotating the reversing nozzle, always aim the spray gun at the floor, as product can stillcome out due to product being trapped between the reversing nozzle and the valve seat.4. Briefly trigger the spray gun so that the pressure eliminates the clog.Note:Only activate the trigger briefly if the nozzle is installed in the reversed direction.7.3.6 HORIZONTAL/VERTICAL SPRAYING1. Secure the spray gun with the locking device.2. Turn the nozzle holder to the desired position.Attention: always turn the nozzle holder clockwise (see illustration) so that the threaded connectioncannot become loose. After turning, check whether the nozzle holder is tight. If not, tighten.Horizontal sprayingVertical spraying