WAGNER GM 5000EA Translation Of The Original Operating Manual

Also see for GM 5000EA: Operating manual Operating manual

Contents

WAGNER GM 5000EA Translation Of The Original Operating Manual Manual pdf 14 page image

14GM 5000EAOPERATING MANUALEDITION 07/2014 ORDER NUMBER DOC 23444994.2.1 SAFE HANDLING OF WAGNER SPRAY DEVICES4.2.2 GROUNDING THE DEVICEIn order to avoid electrostatic charging of the device, the device must be grounded.Friction, flowing liquids, and air or electrostatic coating processes create charges. Flamesor sparks can form during discharge.Ensure that the device is grounded at all times.Ground the work pieces to be coated.Ensure that all persons inside the working area are grounded, e.g. that they are wearingstatic dissipative shoes.Wear dissipative gloves when spraying. The grounding takes place via the spray gunhandle.Grounding of the coating product supply (coating product tank, pump, etc.) is mandatory.The spray jet is under pressure and can cause dangerous injuries.Avoid injection of paint or cleaning agents:Never point the spray gun at people.Never reach into the spray jet.Before all work on the device, in the event of work interruptions and functional faults:– Switch off the energy/compressed air supply.– Relieve the pressure from the spray gun and device.– Secure the spray gun against actuation.– In the event of functional faults: remedy the fault as described in the "Troubleshooting"chapter.The liquid ejection devices are to be checked for safe working conditions by an expert(e.g. Wagner Service Technician) as often as necessary or at least every 12 months, inaccordance with the guidelines for liquid ejection devices (ZH 1/406 and BGR 500 Part 2Chapter 2.36).– For shut down devices, the examination can be suspended until the next commissioning.Carry out the work steps as described in the "Pressure Relief/Work Interruptions"chapter:– if pressure relief is required.– if the spraying work is interrupted or stopped.– before the device is cleaned on the outside, checked, or serviced.– before the spray nozzle is installed or cleaned.In the event of skin injuries caused by paint or cleaning agents:Note down the paint or cleaning agent that you have been using.Consult a doctor immediately.Avoid danger of injury through recoil forces:Ensure that you have firm footing when operating the spray gun.Only hold the spray gun briefly in a position.