8 ProSpray 3.29 • 3.31GBDescription of unit Starting operation3.5 Technical dataProSpray 3.29 ProSpray 3.31Voltage: 110-120 Volt, 50/60 HzMax. current consumption: 13 A 15 APower cord: 3 x 1.5 mm 2 – 6 m or 4.6mAcceptance capacity: 1725 Watt 1840 WattMax. operating pressure: 221 bar (22.1 MPa)Volume flow at 12 MPa(120 bar) with water: 3,0 l/min 3,8 l/minMax tip size: 0.029 inch – 0.032 inch –0.73 mm 0.81 mmMax. temperature of thecoating material: 43°CMax viscosity: 25.000 mPa·sWeight: 43.5 kgSpecial high-pressure hose: DN 6 mm, 15 m, connectionthread M 16 x 1.5Dimensions (L X W X H): 590 x 529 x 726 mmMax sound pressure level: 80 dB (A) ** Place of measuring: 1 m in distance from the unit and 1.6m above the floor, 12 MPa (120 bar) operating pressure,reverberant floor.3.6 TransportationPushing or pulling the unitPull out the handle (Fig. 2, Item 1) until it will come no further. Insertthe handle – push the buttons (2) on the spars, and then push in thehandle.2123.7 Transportation in vehicleSecure the unit with a suitable fastening.4. Starting operation4.1 High-pressure hose, spray gun and separatingoil1. Screw the high-pressure hose (2) to the coating materialoutlet (Fig. 3, Item 1).2. Screw the spray gun (3) with the selected tip onto the high-pressure hose.3. Tighten the union nuts at the high-pressure hoses firmly sothat coating material does not leak.3214. Remove the oil cup cap with a straight-slot screwdriver.5. Fill the oil cup with EasyGlide (Fig. 4) until the oil gauge (4) isshowing that it is full.AttentionEasyglide prevents increased wear and tear to thepackings.6. Replace oil cup cap.7. Press oil button 2-5 times to prime the oiler. Press once forevery eight hours of usage to lubricate the fluid section.