28 1SP4QSBZrGBDescription of unit Starting operation3.5 Technical dataProSpray 3.29 1SP4QSBZVoltage: 220-240 Volt, 50/60 HzMax. current consumption: 7.5 A 8 APower cord: YNN2 – 6 mAcceptance capacity: 1725 Watt 1840 WattMax. operating pressure: CBS .1B7PMVNFóPXBU.1BCBS XJUIXBUFS 3.0 l/min 3.8 l/minMax tip size: 0.029 inch – 0.032 inch –0.73 mm 0.81 mmMax. temperature of thecoating material: $Max viscosity: 25.000 mPa·sWeight: 43.5 kgSpecial high-pressure hose: %/NN N DPOOFDUJPOUISFBE.YDimensions (L X W X H): YYNNMax sound pressure level: 80 dB (A) ** Place of measuring: 1 m in distance from the unit and 1.6NBCPWFUIFóPPS .1B CBS PQFSBUJOHQSFTTVSF reverberant floor.3.6 TransportationPushing or pulling the unitPull out the handle (Fig. 2, Item 1) until it will come no further. Insertthe handle – push the buttons (2) on the spars, and then push in thehandle.2123.7 Transportation in vehicleSecure the unit with a suitable fastening.4. Starting operation )JHIQSFTTVSFIPTF TQSBZHVOBOETFQBSBUJOHoil1. Screw the high-pressure hose (2) to the coating materialoutlet (Fig. 3, Item 1).2. Screw the spray gun (3) with the selected tip onto the high-pressure hose.3. Tighten the union nuts at the high-pressure hoses firmly sothat coating material does not leak.3214. Remove the oil cup cap with a straight-slot screwdriver.5. Fill the oil cup with EasyGlide (Fig. 4) until the oil gauge (4) isshowing that it is full.AttentionEasyGlide prevents increased wear and tear to thepackings.6. Replace oil cup cap.7. Press oil button 2-5 times to prime the oiler. Press once forevery eight hours of usage to lubricate the fluid section.