WB Mfg ELO Desk Assembly Instructions Manual

WB Mfg ELO Desk Assembly Instructions Manual Manual pdf 1 page image

1wibenchmfg.com 507 E. Grant S t. Thorp, WI 54771 • P - 8 0 0 .242.2303V030119 subject to change.ELO® Desk/TableAssembly InstructionsI n s t r u c t i o n s a r e b a s e d o n t h e E LO ® A d a p t D e s k b u t c a n b e u s e d f o r a ny E LO ® D e s k o r Ta b l e .Before you begin, please make sure all parts and proper quantities are included. (See Part Identifier Key page) Any parts damaged during shipment must bereported within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.Step 2To o l s R e q u i r e d• Screw gun• 4mm Hex bit• Drill bit extension• Phillips head screwdriverStep 1:• Place top face down on protected flat surface sothreaded inserts are facing up.Step 2:• Align leg(see leg options below) with threaded inserts.• Connect leg to desktop with the 1/4-20x15mm jointconnector bolt. Use six bolts for each leg.• Use a screw gun, 4mm Hex bit and a drill bit extension totighten the joint connector bolts to the desktop.• Repeat this for the rest of the legs.Step 3:• Adjust legs to desired height then flip over.Step 4:• If your table requires a support bar/s, align the bar/s withthe pre-drilled pilot holes. Use #8x3/4” screws to fastendown the support bar to the desktop.ELO (-ADJ or -EJA)1.25” Square LegsELR (-ADJ or EJA)2” Curved Round LegsELS (-ADJ, EJA or MJA)2” Straight Round LegsELP (-ADJ or EJA)2” Straight Round Pin LegsELO® Leg Options#8 ScrewsSupport barWorksurface(Bottom side)

/ 4

Related manuals for WB Mfg ELO Desk