wc_tx004029gb_FM10.fm98RammerDisassembly and Reassembly4.24 Installing the Carburetor—HondaRequirements ■ Torque wrench■ Plastic sheet to protect work surfaceProcedure Perform the procedure below to install the carburetor.1. Assemble the carburetor (q) as needed.2. Install the five gaskets (s), (t), (u), (w), and (y), one plate (v), and one insulator(x) to the two stud bolts (o).3. Install the carburetor (q), the gasket (r), and the elbow (p), to the two stud bolts(o).4. Fasten using two nuts (n).This procedure continues on the next page.WARNINGFire hazard. Fuel is flammable and may ignite.► Keep all sources of ignition far away while performing this procedure.► Clean up spilled fuel immediately.wc_gr012685qn op rstuv w xy
