Wacker Neuson BS 60-2i Operator's Manual

Also see for BS 60-2i: Repair manual Operator's manual Operator's manual Repair manual Repair manual

Wacker Neuson BS 60-2i Operator's Manual Manual pdf 26 page image

Operation BS 60/BS 70-2iwc_tx000919gb.fm 264.6 Proper OperationSee Graphic: wc_gr002612, wc_gr005332Keep vibratory rammer clean and dry. Avoid no-load strokes. Neverallow the rammer to run full throttle when forcing away material orwhen lifting the equipment.For optimal control, performance, and minimal hand/arm vibration,grasp handle as shown. Hand/arm vibration (HAV) has been optimizedfor this positioning. Reported HAV levels are measured at position Ajust in front of the hand position shown in conformance with EN1033and ISO 5349.Note: The engine is equipped with a low oil level shutoff switch. If theengine stops running after 15-30 seconds, check the oil level in the oiltank and add Wacker Neuson two-cycle oil or equivalent as necessary.The engine is also equipped with an idle shut-off feature. If the engineis operated at idle speeds for over 17-1/2 minutes, it will automaticallyshut off. Allow the engine to stand for 5 seconds before attempting torestart after an idle shut down occurrence.NOTICE: To prevent damage to the rammer, do not allow the rammerto run on its side.If the rammer should tip on its side, place the rammer in the positionshown below, then shut off the engine by moving the throttle controllever through the detent to the off position.wc_gr005332