Wacker Neuson BS 60-2i Operator's Manual

Also see for BS 60-2i: Repair manual Operator's manual Operator's manual Repair manual Repair manual

Wacker Neuson BS 60-2i Operator's Manual Manual pdf 32 page image

Maintenance BS 60/BS 70-2iwc_tx000924gb.fm 325.4 Fuel LinesSee Graphic: wc_gr005334ALWAYS follow the instructions when disconnecting the fuel lines.Failure to do so may result in fuel leaking from the fuel system.To disconnect the fuel lines:5.4.1 Shut off the engine by moving the throttle through the detent to the offposition (a). The engine will stop and the fuel valve will close.5.4.2 Open the fuel cap (b) to relieve normal operating pressure, and thenretighten it.5.4.3 Remove the protective guard.5.4.4 Pinch off both the fuel feed line (c) and the vent line (d) as close to thecarburetor as possible.5.4.5 Carefully remove the fuel lines and drain the fuel left in the fuel linesinto an approved container.Note: In the interests of environmental protection, place a plastic sheetand a container under the machine to collect any liquid which drainsoff. Dispose of this liquid in accordance with environmental protectionlegislation.5.4.6 After service is complete, reconnect the lines to the proper fittings.Reconnect the fuel feed line (c) from the valve to the lower fitting andthe vent line (d) from the top of the tank to the upper fitting.5.4.7 Replace the protective guard.CAUTIONwc_gr005334