Wacker Neuson CRT 36-25 Operator's Manual

Contents

Wacker Neuson CRT 36-25 Operator's Manual Manual pdf 40 page image

wc_tx000640gb.fm40Maintenance CRT 364.14 Engine Oil and Filter (Wacker Neuson engine)Drain the oil while the engine is still warm. To drain oil:1. Remove the filler cap (a) and drain cap (d). Drain oil into a suitable container.Note: In the interests of environmental protection, place plastic sheeting and acontainer under the machine to collect the liquid which drains off. Dispose of thisliquid properly.2. Re-insert the drain cap and tighten.3. Fill the engine with the recommended oil to the upper limit mark on the dipstick(b). See section Technical Data for the oil quantity and type.Burn hazard. Care must be taken when draining hot engine oil. Hot oil can burn!To change the filter:1. Drain the engine oil. Remove used filter.2. Before installing the new filter, lightly oil the filter gasket (c) with fresh, cleanengine oil. Screw the filter on by hand until the gasket makes contact, thentighten an additional 7/8 turn.3. Fill the engine with the recommended oil. See section Technical Data for oilquantity and type.4. Start and run the engine to check for leaks. Stop the engine. Recheck the oillevel and add oil if required. Refer to the engine owner’s manual.WARNINGwc_gr004396abcddWM 720WM 650WARNINGMost used oil contains small amounts of materials that can cause cancer and otherhealth problems if inhaled, ingested, or left in contact with skin for prolongedperiods of time.f Take steps to avoid inhaling or ingesting used engine oil.f Wash skin thoroughly after exposure to used engine oil.