Wacker Neuson GP 6600A Operator's Manual

Wacker Neuson GP 6600A Operator's Manual Manual pdf 22 page image

Operation GP/GPS 6600A223.5 Wheel KitThe wheel kit (Part No. 0161308) is a standard item on Item Number0620012, 0620015, 0620043 and 0620046 only. It is available as anoption on all other models.3.5.1 Hoist the generator, and align the axle (c) with the lower cross-memberof frame.3.5.2 Insert the axle brackets (k) over the axle and align the holes found inthe axle bracket to the holes of the cross-member. Ensure that thebrackets extend under the tube of the frame.3.5.3 Insert M6 x 16 screws (l) through the outer holes on the cross-member,then through the holes of the axle bracket.3.5.4 Insert M6 nuts (m) onto the screws and tighten. Torque to 7.5 Nm (5.25ft.lbs.).3.5.5 Assemble the washers (g) next to the rings (h), then add the wheels(d).3.5.6 Add the washers (g) next to the wheels, then insert the pins (f) into theholes of the axle and separate the legs of the pins.3.5.7 Align the holes found in the leg bracket (b) to the holes of the lowercross-member.3.5.8 Insert M6 x 16 screws (l) through the outer holes on the cross-member,then through the holes of the leg bracket.3.5.9 Insert M6 nuts (n) onto the screws and tighten. Torque to 7.5 Nm (5.25ft.lbs.).3.5.10 Insert M8 x 30 screw (o) through the hole in the leg bracket andthrough the hole in cross-member.3.5.11 Insert M8 nut (p) onto the screw and tighten. Torque to 18.75 Nm (13.5ft.lbs.).3.5.12 Align the holes in the rubber foot mounts (e) to the holes of the legbracket.3.5.13 Insert M6 x 20 screws (m) through the leg bracket, then through theholes of the rubber foot mounts.3.5.14 Insert the nuts (n) onto the screws and tighten. Torque to 7.5 Nm (5.25ft.lbs.).3.5.15 Align the holes found in the handles (a, j) to the holes of the brackets(1) on the frame.3.5.16 Insert M6 x 16 screws (l) through the handles, then through thebrackets on the frame.3.5.17 Insert nuts (m) onto the screws and tighten. Torque to 7.5 Nm (5.25ft.lbs.).