Wahl Mini Arco General Safety Instructions Intended Use

Also see for MINI ARCO: Instructions

Mini ArcoGeneral safety instructionsIntended use·· Only use hair clippers to cut human hair, beard hair and eyebrows.·· Only use animal clippers to cut animal hair and animal fur.Requirements on the user·· Read the operation manual in full and familiarise yourself with it before the first use.·· This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience andknowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Childrenshould be supervised to ensure that they do not play with the appliance.·· Keep the appliance out of reach of animals and protected against the effects of the weather.HazardsPlease adhere to the following safety instructions!Danger! Electric shock due to damage to appliance/plug-in transformer.} Do not use the appliance if it is not working correctly, if it is damaged or if it has fallen into water. Repairs may only be performed at an autho-rised service centre using original spare parts, in order to avoid hazards.} Never use the appliance if the mains cable or plug-in transformer is damaged. A damaged mains cable or plug-in transformer may only bereplaced with an original spare part, by an authorised service centre or another similarly qualified person, in order to avoid hazards.} Only specialists properly trained in the handling of electrotechnical appliances may repair electrical equipment.Danger! Electric shock due to penetration of liquid.}Never touch electrical equipment that has fallen into water. Disconnect from the mains immediately.}Never use electrical equipment in the bath or under the shower.Always position or store electrical equipment where it cannot fall into water (e.g. washbasin). Prevent electrical equipment from coming into con-tact with water and other liquids.}Only use and store the appliance in dry rooms.}As additional safety measure, it is recommended that a tested residual current appliance (RCD) with a residual operating current of not morethan 30 mA be installed in the bathroom circuit.Danger of explosion!}Never use the appliance where aerosol (spray) products are being used or where oxygen is released.}Do not attempt to replace the battery.}Do not expose the appliance to temperatures below 0°C and above +40°C for any length of time. Avoid direct exposure to sunlight.Warning! Injuries due to incorrect handling.}To prevent injury, never use the appliance if the blade set is damaged.}Always switch the appliance off before storage, as the appliance can fall down due to the vibrations.Handle with care! Damage due to incorrect power supply.}Only operate the appliance with an alternating current and with the voltage stated on the nameplate.Handle with care! Injuries due to incorrect handling.}Only use accessories recommended by the manufacturer.}Only use the plug-in transformer that is included in the scope of supply for charging the appliance. Only replace defect plug-in transformers withoriginal spare parts which you can order via our service centres.}Never insert or allow objects to fall into the openings of the appliance.}Do not hold the appliance by the mains cable to carry it, and do not use the cable as a handle.}When disconnecting the appliance from the mains, never pull on the mains cable or on the appliance itself.}Do not wind the mains cable around the appliance.}Keep the mains cable and appliance away from hot surfaces.}Make sure that the mains cable is not twisted or kinked when charging or storing.}Do not use disposable batteries. Batteries should only be replaced at authorised service centres.Product descriptionDescription of parts (Fig. 1)A Blade setB On/off switchC Charging indicator lightD Appliance socketE Attachment comb small = cutting lengths 3 mm and 6 mmF Attachment comb large = cutting lengths 9 mm and 12 mmG Cleaning brushH Oil for blade setI Plug-in transformerJ Appliance plugTechnical data Hand-held appliance Drive unit: DC motorBattery: NiMH batteryOperating time: up to 100 minutesDimensions (LxWxH): 149 x 40 x 36 mmWeight: approx. 140 gEmission sound pressure level: max. 66 dB(A) @ 25 cmVibration: < 2.5 m/s2Plug-in transformer Type: adapter 6000Power consumption: max. 12 WOperating voltage: 100 – 240 V~ / 50 – 60 HzThe appliance is safety insulated and radio screened. It meets the requirements of EU Electromagnetic Compatibility Directive 2004/108/EC andMachi ery Directive 2006/42/EC.