Walchem WDT400 Series Instruction Manual

Walchem WDT400 Series Instruction Manual Manual pdf 29 page image

5.12 Config MenuThis menu allows you to export a file that contains all of the set points in the controller to a USB flashdisk drive, and then later import the set points into another controller.Export Config Place a USB flash drive with at least 10 MB capacity into the USB port on the front panel of thecontroller. Press the Enter key to export the configuration file from the controller to the stick. The filename will be UCF.ini. If you are exporting files with different set points you may rename the file tosomething that describes it, as long as it has an ini extension.The controller will display the progress of the file download process. If the file was successfullyexported to the USB disk the controller will display Transfer Success, otherwise Transfer Fail 1.Transfer Success Transfer Fail 1Import Config Place a USB flash drive that contains only one configuration file stored on the root directory of thestick into the USB port on the front panel of the controller. Press the Enter key to import theconfiguration file from the stick to the controller. The file name must have an ini extension in itsname.The controller will display the progress of the file import process. If the file was successfully importedfrom the USB disk the controller will display one of the messages below:Import Failure Indicates that there were problems connecting to or accessing the USBstick.Import Success:Any key to rebootThe configuration file import succeeded and will be ready for use afterreboot.File Open Failed A config file could not be found on the USB stick or the USB stick filesystem could not be accessed.File Read Failed The config file is too short (incomplete) or empty.Invalid CFG File The imported file is not a valid config file.Invalid Model The imported config file is not for this controller model.Wrong SW Version The version of the imported config file is not compatible with thiscontroller software version.Corrupt CFG File The imported config file is corrupt. (The checksum failed.)Wrong file Size The size of the imported config file is wrong.Figure 18 Config Menu26