Waldorf IN8200E Installation And Operation Manual

Contents

7InstallationInstallation RequirementsNOTE: It is most important that this Induction Cooktop is installed correctly and that operation iscorrect before use. Installation shall comply with local electrical and health and safetyrequirements.Waldorf Induction Cooktops are designed to provide years of satisfactory service, and correct installation isessential to achieve the best performance, efficiency and trouble-free operation.This appliance must be installed in accordance with National installation codes and in addition, inaccordance with relevant National / Local codes covering gas and fire safety.Australia / New Zealand AS/NZS 3000 - Wiring Rules.United Kingdom: BS 7671 - Requirements for Electrical Installations.Installations must be carried out by qualified persons only. Failure to install equipment to therelevant codes and manufacturer’s specifications shown in this section will void thewarranty.Components having adjustments protected (e.g. paint sealed) by manufacturer, are onlyto be adjusted by an authorised service agent. They are not to be adjusted by the installationperson.Unpacking Remove all packaging and transit protection from the appliance including all protective plasticcoating from the exterior stainless steel panels. Check equipment and parts for damage. Report any damage immediately to the carrier anddistributor. Report any deficiencies to the distributor who supplied the appliance. Check that the available electrical supply is correct to that shown on the Rating Plate attached to theunderside of the R/H side, front Induction Cooktop lower trim.Location1. Installation must include adequate clearance and ventilation.2. Position the appliance in its approximate working position.3. The legs must always be fitted. Ensure that the legs are securely attached.ClearancesNOTE: Only non-combustible materials can be used in close proximity to this appliance.Combustible Surface Non Combustible SurfaceLeft / Right Hand Side 50mm 0mmRear 50mm 0mm