Walker MB (18 HP) Owner's Manual

Also see for MB: Parts and owners manual Detailed instructions

Contents

Walker MB (18 HP) Owner's Manual Manual pdf 53 page image

51Maintenance Instructions ADJUSTMENTS/ELECTRICAL SYSTEMADJUSTMENTSSteering LeversAn adjustment range of approximately 3 inches isavailable on the steering levers - the levers can be ad-justed forward or aft depending on the arm length ofthe operator. The levers can be adjusted by loosen-ing the locknut at the pivot point and the locknut hold-ing the lever in position in the adjustment slide.Adjust levers into most comfortable position andtighten both locknuts.Steering Lever AdjustmentTilt-Up Deck Adjustable StopWhen the carrier frame hinge joint is properly ad-justed, the deck lock levers should move in and outof the engaged and disengaged positions freely. Allfour hitch pins used for height adjustment should sitflush on the washers above the deck pin bushing.On a level surface, if any pin is sticking up (likely thefront pins), tighten the opposite side or loosen thesame side to lower the pin. Adjustments are madeby loosening the jam nut and tightening or loosen-ing the set screws on the Deck Mount Pivot Brack-ets. Retighten the jam nut when the adjustment iscomplete.Tilt-Up Deck Adjustable StopELECTRICAL SYSTEMFor troubleshooting, refer to the Wiring Diagram.IMPORTANT: Disconnect both battery cables be-fore unplugging any wiring connectors or making re-pairs on the electrical system.AdjustmentSlideLocknut(Pivot Point)Locknut(Position)Set ScrewJam Nut