Maintenance Instructions REPLACING/REPAIRING69Fuel FilterModel MT is equipped with an in-line fuel filter. Vi-sually inspect the filter periodically, and replace thefilter yearly.Fuel Filter LocationIMPORTANT: Replace the fuel filter only in a cleanarea where the fuel line and connections will not becontaminated by any dust and dirt.1. Close the fuel tank shut-off valve.2. Expand and slide clamps on either side of thefilter away from filter and pull fuel lines off filter.3. Replace filter.4. Open fuel tank shut-off valve.Fuel Shut-Off Valve and FilterBlade Overload Shear BoltsNOTE: Shear bolts are not used on the DSD62mower deck.The cutting blade is keyed to the blade hub by two(2) shear bolts (10-24 x 5/8 in. stainless steel ma-chine screws). These bolts are designed to shearand protect the blade drive gearbox from damage ifthe blade encounters a shock load.Cutting Blade Shear BoltsNOTE: Tightening the 5/8-18 blade mounting nutto 60 ft-lb (81.3 N⋅m) is also important for propershock load protection. It is important to not over-tighten the mounting nut since this defeats (over-rides) the function of the shear bolts.If these bolts shear, remove the blade and install newbolts. Refer to CHECKING/SERVICING in this sec-tion for Sharpen Mower Blades which describes theblade removal and installation procedure.DANGERGasoline is extremely flammable and canbe highly explosive. To minimize danger:• Use only an approved fuel container forgasoline.• DO NOT allow open flames or sparksnear the machine while performing main-tenance or refueling; DO NOT smokewhile working with fuel.• Wipe up spilled gasoline immediatelyand completely.In-LineFuel FilterTurn ValveClockwise to CloseCutting BladeShear Bolts