Splitter Operation WXR545PLTrailer Wood Splitter225.2.2 High Speed Position (2)• Pushing the lever forward to High Speed position(2) at the first detent provides a higher cylinderextension speed. In this position the cylinderextends at high speed, but lower power.• Releasing the lever returns it to STOP.5.2.3 High Power Position (1)• Push the control lever fully forward to High Powerposition (1) for maximum power. The cylinderextends at a slower speed but provides higherpower to push the wedge or push block throughthe wood for effective splitting.• Releasing the lever returns it to STOP.5.2.4 Retract Position• Pull the lever fully backwards to retract the wedge/ push block. The valve detent holds the lever inretract allowing a hands-free return cycle.• The valve lever returns to STOP (neutral) whenwedge / push block is fully retracted.• The lever can be moved out of Retract into STOPat any time.5.3 Tilting Splitter BedThe WXR545PL models with the Tilting Splitter Bed havea pivoting main frame that allows the splitter to be used inthe horizontal, angled, or vertical positions. Position thesplitter bed for the best application.See Machine Set-up on page 26.6. Splitter OperationWallenstein WXR Trailer Wood Splitters are self-containedmachines designed to push a wedge through the woodto split it. The WXR545PL splitter can be used in thevertical, angled, or horizontal configuration.The operator has the responsibility of being familiarwith all operating and safety procedures andfollowing them.6.1 Before Starting the Engine1. Check the engine oil level. See page 24.2. Check the hydraulic oil level. See page 24.3. Check the fuel level.4. Check the engine air cleaner. See page 25.5. Review the Safety Rules on page 96. Clear the area of bystanders, especially smallchildren.7. Make sure each operator is trained and familiar withthe set up and operation of the wood splitter.8. Follow the Pre-Operation Checklist.9. Review the Controls (see page 20).10. Survey the work site and place the wood splitter in aclear, level work area.11. Set up the machine correctly. See Machine Set-up onpage 26.