Wayne-Dalton TORQUEMASTER 6100 Installation Instructions And Owner's Manual

Also see for TORQUEMASTER 6100: Quick start guide

Contents

Tools Needed:14Tools Needed:Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to yourlocal yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.comvertical TrackIMPORTANT: ThE TOPs Of ThEVERTICal TRaCks MusT bE lEVElfROM sIDE TO sIDE. If ThE bOTTOMsECTION Was shIMMED TO lEVEl IT.ThE VERTICal TRaCk ON ThE shIMMEDsIDE, MusT bE RaIsED ThE hEIGhT OfThE shIM.Position the left hand vertical trackassembly over the rollers of the bottomsection. Make sure the counterbalancecable is located between the rollersand the door jamb. Drill 3/16” pilotholes into the jambs for the lagscrews. loosely fasten jamb bracketsand flagangle to the jamb using5/16” x 1-5/8” lag screws. Tighten lagscrew securing bottom jamb bracket tojamb, to maintain 5/8” spacing. hangcable drum over flagangle.Repeat for the right hand side.3/16” Drill bitPower Drill7/16” socketDriverTape Measurelevelstep ladder11 bOTTOM sECTIONVERTICal TRaCkROllER 5/8”15R qI flaGaNGlE12R qI flaGaNGlE12R & 15R fullyaDjusTablE flaGaNGlElaGsCREWlOCaTIONslaGsCREWlOCaTIONslaGsCREWlOCaTIONslaGsCREWquICk INsTalljaMb bRaCkETbottom SectionCenter the bottom section in the dooropening. level section using woodenshims (if necessary) under the bottomsection.level10bOTTOM sECTIONWEaThER sEallEVElWOOD shIMs(If NECEssaRy)bOTTOMsECTION5/16” x1-5/8” laGsCREWsflaGaNGlEVERTICalTRaCkassEMblyq.I. jaMbbRaCkETjbus jaMbbRaCkET