WAYNE COMBUSTION SYSTEMS801 GLASGOW AVE.FORT WAYNE, IN 46803ELECTRIC SHOCK HAZARDOVERHEATING HAZARDHIGH VOLTAGES ARE PRESENT IN THIS EQUIPMENT.FOLLOW THESE RULES TO AVOID ELECTRIC SHOCK.s Use only a properly grounded circuit. A ground faultinterrupter is recommended.s Do not spray water directly on burner.s Turn off power before servicing.s Read the owner’s manual before using.SHOULD OVERHEATING OCCUR:s Shut off the manual gas valve to the appliance.s Do not shut off the control switch to the pump or blower.SPECIFICATIONSFOR YOUR SAFETYIF YOU SMELL GAS:1. OPEN WINDOWS2. DON’T TOUCH ELECTRICAL SWITCHES3. EXTINGUISH ANY OPEN FLAME4. IMMEDIATELY CALL YOUR GASSUPPLIER.THESE INSTRUCTIONS SHOULD BEAFFIXED TO THE BURNER ORADJACENT TO THE HEATINGAPPLIANCE.FOR SHIPPING PURPOSES, THE FLAMESPREADER IS FULLY RETRACTED.FLAME SPREADER ADJUSTMENT ISMANDATORY AND EFFECTS BURNERIGNITION AND PERFORMANCE.MODELSP250AF P265 P265EPP250AFEP P265F P265DIP250AFDI P265FEPGAS BURNERPublication Date 5/01 - Revision B - Manual 101220NOTE: Dimensions in ( ) are informational only. English values take priority.WARNING: If the information in theseinstructions is not followed exactly, a fire orexplosion may result causing propertydamage, personal injury or death.- Do not store or use gasoline or other flammable vaporsand liquids in the vicinity of this or any other appliance.- WHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electrical switch; do not use anyphone in your building.• Immediately call your gas supplier from a neighbor’sphone. Follow the gas supplier’s instructions.• If you cannot reach your gas supplier, call the firedepartment.- Installation and service must be performed by a qualifiedinstaller, service agency or the gas supplier.CARBON MONOXIDE IS A COLORLESS, ODORLESS GASTHAT CAN KILL. FOLLOW THESE RULES TO CONTROLCARBON MONOXIDE.s Do not use this burner if in an unvented, enclosed area. Carbonmonoxide may accumulate.s Do not adjust the pressure regulator. High pressures producecarbon monoxide.s Check flue gases for carbon monoxide. This check requiresspecialized equipment.s Allow only qualified burner service persons to adjust the burner.Special instruments and training are required.s Read the owner’s manual before using.CARBON MONOXIDEPOISONING HAZARDNOTICEBURNER MODELS MINIMUM INPUT MAXIMUM INPUT FUELSP250AF & P250AF-EP & P250AFDI 50,000 BTU/Hr (14.65 kW/Hr) 250,000 BTU/Hr (73.27 kW/Hr) Natural & L.P. GasP265 & P265EP 65,000 BTU/Hr (19.05 kW/Hr) 200,000 BTU/Hr (58.61 kW/Hr) Natural & L.P. GasP265F & P265FEP 65,000 BTU/Hr (19.05 kW/Hr) 200,000 BTU/Hr (58.61 kW/Hr) Natural & L.P. GasELECTRICAL Power Supply - 115V/60HZ 1 Ph. MOUNTING: Adjustable Flange is StandardPedestal Mount is Optional.