FD-6045-CE and FD-8645-CEFire Deck Installation and Operation ManualPG 9 OF 32M0042�13 JULY 2019OPTIONAL TEMP CASTER INSTALL1 Use a forklift (or pallet jack) to raise the ovenusing the front or rear forklift pockets�INSTALLATIONINSTRUCTIONS FOR INSTALLING AND REMOVING OPTIONAL OVEN CASTERSFire Deck ovens are VERY heavy.Do not attempt to move the oven over any type of grade or sloped surface when using the Casters or Pallet Jack.WARNING: Failure to follow these instructions may result in severe injury or death.If you have any questions contact your local distributor.NOTE: The casters will add 76mm (3") to the total height of the oven.The 100mm (3-3/4") Vent Shield on top can be removed temporarily if necessary.Shipping Casters are for moving the oven only. THEY MUST BE REMOVED ONCE THE OVEN IS IN PLACE.3 Once at final destination, use two scissor jacks (orpallet jack) to lift the one side of the oven by placingone jack under each caster assembly�Raise the oven just high enough so the wheels clearthe floor�Unbolt each Caster and remove it�Note: Casters are for moving oven only� They must beremoved once the oven is in place�4 Lower the oven back to the ground�Remove the Self-Drilling Screw and slide the rest ofthe Caster Assembly out of the fork pocket�Install Fork Pocket Cover�Repeat steps 3 and 4 for the other side of the oven�This oven is designed to be sealed to the floor uponinstallation using a silicone sealant acceptable to thelocal health official� See the Placing & Installationsection of this manual�Caster Bolts2 Insert a Caster Assembly into each of the sidefork pockets and secure it to the oven with aSelf-Drilling Screw and washer�Install the screw through the Mounting Tab�Once the Caster Assemblies are installed, lowerthe oven�It may then be rolled over a smooth, FLATsurface to its final destination�Self-Drilling Screw& Washer throughMounting Tab