Wood Stone MOUNTAIN Series Installation And Operation Manual

Also see for MOUNTAIN Series: Service manual Installation and operation manual Installation and operation manual Installation and operation manual

Wood Stone MOUNTAIN Series Installation And Operation Manual Manual pdf 36 page image

PG 36 OF 48M0037�09 SEPTEMBER 2019Mountain Series CEInstallation and Operation ManualRFG-(W) OPERATIONDAILY OPERATION FOR RFG-(W) MODELSIMPORTANT: If at any time you feel that the burner is not operating properly, TURN THE OVEN OFF and call for service� Beforeservicing, disconnect the electrical supply at the breaker and turn off the gas supply at the appliance’s individual gas shutoffvalve� In the event of a power failure, no attempt should be made to operate the oven�DAILY STARTUP1. Remove the Night Heat Retention Door(s)�2. Push ON/OFF button� Using the Flame Height Control Knob, turn the radiant flame to its highest setting� Check yourtemperature after approximately one hour� If you are close to your desired temperature, reduce your flame to the holdingflame setting that corresponds to your desired temperature� See the FLAME HEIGHT CONTROL section that follows todetermine the proper setting that will correspond to your desired temperature� The Hearth Temperature readout will display“LO” until the oven floor reaches 100 °F�Green light indicates the system is energized�Green light indicates the pilot flame for the radiant burner is lit�ADJUSTING THE RADIANT (DOME) FLAMETo adjust the radiant flame: The radiant flame is always on (when oven is operating) and can be adjusted to any flame intensitybetween its highest and lowest setting� Simply turn the knob located to the lower left of the doorway, beneath the mantle�HOW TO READ FLOOR TEMPERATUREThe floor temperature is continuously displayed by the controller in the upper window� This reading is being taken by athermocouple about 25 mm (1") below the floor surface, so the actual surface temperature may be somewhat different, and isbest measured using a non-contact (IR) thermometer� Note: The display will read “LO” when the temperature is below 38 °C(100 °F)�For additional information on temperature control, see the FLAME HEIGHT CONTROL section of this manual�FOR MODELS APPROVED TO ALSO BURN WOODSee the BURNING WOOD section of this manual for information on burning wood� Models listed to burn wood will have a -W atthe end of the model number�TURNING OFF THE OVEN1. Push the ON/OFF button� All gas will go off, including the pilots�2. Put the Night Heat Retention Door(s) in place to retain heat�