An ongoing program of product improvement may require us to changespecifications without notice. WS-MS-(4, 5, 6, 7)-W-IR,Revised May 2015. Doc no: M0036.047Mountain SeriesInstallation and Operation Manualinfo@woodstone-corp.com or visit woodstone-corp.comWood Stone Corporation1801 W. Bakerview Rd.Bellingham, WA 98226 USAToll Free 800.988.8103Tel 360.650.1111Fax 360.650.1166INSTALLATION CLEARANCESPLEASE READ THIS ENTIRE MANUAL BEFORE YOU INSTALL THE OVEN. FAILURE TO FOLLOWINSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH. CONTACT YOURLOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION IN YOURAREA.! WARNING: Installation and servicing of this product could expose you to glasswool/ceramic fibers as well as Calcium Silicate dust. ALWAYS WEAR RESPIRATORY AND EYEPROTECTION WHEN INSTALLING OR SERVICING THIS APPLIANCE. Please read this entiremanual before you install the oven. Failure to follow instructions may result in propertydamage, bodily injury or even death. Contact your local building or fire officials aboutrestrictions and installation inspection in your area.CLEARANCES1. The Wood Stone gas-fired oven must have a minimum 1" clearance to combustibles from all sides, and 14"clearance to combustibles from the top (see INSTALLATION CLEARANCES section on next page)� If building afacade that will contact the oven, use completely non-combustible materials*� Please note that standard Drywall (orSheetrock) is considered a combustible�2. Any facade materials 6" to either side of the oven doorway and above must be constructed of non-combustiblebuilding materials�3. Install this oven only on a non-combustible floor surface� (Cet appareil doit être installé sur une surface deplancher non-combustible�) The non-combustible floor surface should extend 36" out in front of the oven, andextend 30" to either side of the oven doorway�*When non-combustible building materials contact the body of the appliance, the clearances to combustibles aretransferred to those non-combustibles�NOTICE: For stucco-ready appliances (model numbers ending in “-S”), the same clearances as described above apply�Non-combustible stucco mix must be used and applied to a minimum thickness of 1"�IF THIS OVEN IS NOT PROPERLY INSTALLED A FIRE MAY RESULT. TO REDUCE THE RISK OF FIRE, FOLLOWTHESE INSTALLATION INSTRUCTIONS. A MAJOR CAUSE OF OVEN RELATED FIRES IS FAILURE TO MAINTAINREQUIRED CLEARANCES (AIR SPACES) TO COMBUSTIBLE MATERIALS. IT IS OF UTMOST IMPORTANCE THATTHIS OVEN BE INSTALLED ONLY IN ACCORDANCE WITH THESE INSTRUCTIONS.WARNING: DO NOT PACK REQUIRED AIR SPACES WITH INSULATION OR OTHER MATERIAL.