Wood Stone TANDOOR CE Series Installation And Operation Manual

Also see for BARREL TANDOOR: Installation and operation manual Installation and operation manual

PG 12 OF 20M0054�07 J ULY 2019Tandoor CE Installationand Operation ManualLOWER FLASHING INSTALL (BARREL)DO NOT LOWER STRIP FLASHING UNTIL TANDOOR IS LOCATED IN ITS FINAL INSTALLED POSITIONDO NOT REMOVE PROTECTIVE TAPE FROM BOTTOM OF TANDOOR UNTIL STRIP FLASHING IS LOWEREDLeveling the TandoorPosition Tandoor in its final installed position�With the Flashing still in the UP position, levelthe Tandoor using the four adjustable feet�Plumbing the TandoorIf the gas connection is made below the Tandoor,plumb before lowering the Flashing�If the gas connection is not from below the Tandoor,it will be necessary to notch the Flashing�This should be done after the Flashing is lowered�Lowering the FlashingThe unit ships with the Strip Flashing secured intoits “UP” position with a screw at each leg�Installing the Flashing FillerRemove screws and nuts from Flashing Filler�Open Control Box�Position the Filler so it spans the gap between endsof the Lower Flashing�Align the the holes in the Filler with the holes in theLower Flashing�Fasten with the screws and nuts previously removed�Screw holdingup flashingRemove the screw from all 4 legs and lower theFlashing evenly around the Tandoor, flat to the floor�Center punch and pre-drill each Leg using theexisting hole in the Flashing as a guide�Secure the flashing at each leg using theself-drilling screw previously removed�Center punch andpre-drill using theexisting hole as a guide,then fasten with screw• • • •Ü• • • •Ü• • • •Ü