Wood Stone WS-BH-4355-RFG Installation And Operation Manual

Also see for WS-BH-3030-RFG: Installation and operation manual Installation and operation manual

Contents

Bistro Installation and Operation ManualQuestions? Call Wood Stone at 1-800-578-6836 28May2008C) Timer Mode OperationWhen the timer is programmed for 'ON'/'OFF' mode operation (see “B” above) and the time of dayreaches the programmed 'ON' time, the oven controls will be switched on and the clock face icon willflash until the off time is reached, at which time the clock face icon will go off.If the oven is turned on manually while the timer is set, the clock face icon will start flashing indicatingthe 'OFF' function is still enabled, and the oven will still shut off at the preset time.If the oven is manually turned off before the preset time is reached, the preset time will be overriddenand the clock face icon will go out.D) Minute (Count Down) Timer OperationTo set the count down time, press and hold either the 'Hr' or 'Mn' button for 5 seconds. The display willstart flashing '0:00'. Use the 'Hr' and 'Mn' button to set the desired count down time. The display willcontinue to flash the count down time. To start the count down timer, press the 'ON' button once. Thedisplay will show solid with only the colon flashing at a rate of once per second, showing the timer isrunning. When the timer counts down to '0:00', the beeper will sound 1 second on and one second offfor 30 seconds The timer will then beep once every 10 seconds until it is reset by pressing the 'OFF'button. Pressing the 'OFF' will silence the beeper and the display will revert to clock mode showingthe time of day.The timer function can be canceled by holding the 'ON' “and 'OFF' buttons down at the same time for5 seconds.E) Clock/Timer Operation During a Power OutageIn the event of a power outage, the clock will continue to display the correct time for several hours. Theminute timer may be used during a power outage, but the beeper will not sound. Programmed 'ON'/'OFF'times will remain active unless the programmed 'ON' time is reached before power is restored, in whichcase the program will be canceled and the clock face icon will go out. If power is restored before theprogrammed 'ON' time is reached, the oven will work normally at the preset times.If the power remains off for an extended period the clock will eventually turn off (go blank) and will flash'AM 12:00' once the power is restored and must be reset per the instructions in section A above.F) External ControlIf the oven is turned on manually when the timer is programmed for 'ON'/'OFF' times, the 'ON' timewill be canceled, but the 'OFF' time will remain programmed. The clock face icon will blink to indicatethis. If the oven is then turned off manually the 'OFF' time will be canceled and the clock face icon willgo out.Programming