X7968r / X7967r / X7927r / X7922r User’s Guide74The USB cable provided has a flat connector on one end (called Type A) and a squareconnector on the other (Type B). Connect the flat connector to your PC and the squareconnector to the device.To ADSL-Ethernet routerTo PCFigure 85: USB Cable ConnectorsIf a Microsoft digital signature dialog box is displayed, click Yes to continue.A window displays briefly, indicating that the system has found new hardware, and theInstalling window displays as the installation finishes.You have now finished installing the driver. You do not need to restart your computer.Proceed to Part 2. Configuring IP properties on the USB PC.Part 2. Configuring IP properties on the USB PCNow that the USB driver installation is complete, you must configure the USB PC so that itsIP properties place it in the same subnet as the device’s USB port. There are two ways to dothis:The device is configured to assign an appropriate IP address to the USB PC. If you want touse this automatic assignment feature, called “DHCP server,” you must configure the USBPC to accept dynamically assigned IP information. Follow the instruction on ConfiguringEthernet PC section that corresponds to the operating system installed on your PC.If you want to assign a static IP address to the PC, follow the instructions on ConfiguringEthernet PC section and use the following information:In the Network and Dial-up Connections window, be sure to select the icon that correspondsto your new USB connection (not the one that corresponds to your Ethernet NIC). When youdisplay properties for the icon, the following text should display in the Connect Using textbox: USB IAD LAN Modem #n The USB port on the device is preconfigured with these properties: USB port IP address:192.168.1.100 (for example)USB port subnet mask: 255.255.255.0Therefore, your PC must be configured as follows:IP address: 192.168.1.n where n is a number from 2 to 254 that does not conflict with theDHCP address range.Subnet mask: 255.255.255.0