XFP USER MANUAL & LOG BOOK • Approved Document No. DFU2000501 Rev 2 • Page 20 of 28XFP NETWORKABLE ANALOGUE ADDRESSABLE FIRE ALARM PANELSYSTEM SET-UP DATA CHARTImportant: this page should be carefully completed by the system engineer prior to handover.ZONE FUNCTIONSTick the appropriate column for each zone. Note that zones 17-32 are only available on 1-32 zone panels.ZoneNo.Zonedescription Set up fornormal operationSet up withdependenciesSet up with aninvestigate facilitySet up withoutput delays1234567891011121314151617181920212223242526272829303132ACCESS LEVEL 2 (AUTHORISED USER) CODEThe factory default code for access level 2 (required on push button versions of the panel only) is 3 3 3 3(four presses of the6key). If this code is changed, make a note of the changes here:-New access level 2 code q q q q Date changed __________________ADDITIONAL INFORMATIONWe recommend any additional information the user needs to be aware of is detailed below:-_____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________Completed by ____________________________________ of ______________________________________ on ____ / ____ / ____