XTBA DALI Watch Manual Page 6 of 26Product # - 03/2013© XTBA 1986 – 2013Receive Menu LoopReceive Levels View Commands Live View Command History ViewRaw Data Command Compare Receive Group Levels Flicker FinderReceive Levels: Pressing the Yes button will enter the receive function. Thisallows you to view any DALI levels (arc power commands). Group levelcommands are ignored as they have their own menu below. If there is noDALI being received the Watch will let you know with the message ‘NO DALIINPUT’.C H : 1 2 3 4R X % 0 0 0 0The upper line shows the channel number and the lower the level received.Next to the RX is a % symbol if the unit is set for percent or D if set fordecimal (see user options). The RX tells you that you are in receive as thetransmission display looks the same but with a TX.Use the Left and Right buttons to scroll through the DALI channels.View Commands Live: (see user options for arc power / level blocking andrepeat command blocking)The unit will monitor the data line and will display commands received. If levelblocking is enabled only non-level commands will be received. The XTBADALI Watch will only display new commands so if a single command is sentagain it will be ignored after the first time unless repeat command blocking isturned off.Pressing the Yes button with the View Commands Live menu displayed thedisplay might look like this once a command has been received.Command Number address, group or broadcastC O M N o 0 @ S . A D D 0O F FCommand DescriptionOn entry any existing command history will be cleared. The top line tells youthe command number and if it is a short address, group or broadcast. If itreceives a group command the top right will change to GROUP with the groupvalue and if broadcast the top right will change to ALL.With commands that do not have a short address/group or/broadcast e.g.some high commands such as Terminate the top right will be blank.The second line gives the command description. The display will update asany new commands are received.View Command History: Command history will allow you to view the last 250command pairs received. It can be used in two ways. When in ‘ViewCommands Live’ pressing the Menu button will enter the history display.