XVision X720D User Manual

Contents

XVision X720D User Manual Manual pdf 18 page image

13the cable from the side port of the cable channel when you are installing the device cable. And thenyou can draw out the cable from the cable channel of the pedestal.Step 3Adjust the device installation pedestal to the proper position and then draw the cable through the cableexit you just dug in the ceiling (wall). Line up the TOP direction of the device to the installation positionmap and then line up the three screw holes in the device pedestal to the three plastic expansion boltholes in the installation position. Put the three self-tapping screws in the three plastic expansion boltsfirmly. Now the dome camera is secure in the installation surface.Step 4Loosen the two M3 secure screws of the lens rotation structure (Do not remove, loosen a little bit willbe OK.). Use the inner hexagonal wrench to insert them to the inner hexagonal holes and then use thewrench to turn the lens. Adjust the lens to the proper monitor angle and then secure the screws of thelens rotation structure. The lens adjust angle ranges are: flip (0°~+75°),video pan rotation (-15°~+15°) , video rotation angle(-15°~+15°).Step 5Line up the dome camera cover to the cable exits and put the cover back. Use the inner hexagonalwrench to secure the three inner hexagonal screws firmly. Now the installation completed.Note:The device GND cable can effectively enhance the device reliability. The GND hole is near the cableexit of the back of the enclosure. The GND screw specification is M3. See Figure 3-3.Figure 3-33.2 SD Card InstallationImportantSome series product do not support the SD card storage function.Please shut down the power and then turn off the device before you install the SD card.