Xerox 480 ST System Administration Manual

Also see for 490ST - Document Centre B/W Laser Printer: Reference guide User guide

Contents

Xerox 480 ST System Administration Manual Manual pdf 16 page image

Page 1 - 2 Xerox Document Centre System Administration GuideHow to Use this DocumentThis document has been arranged to get the printer set up on yournetwork quickly and with minimum reading.1. Before connecting network cabling to the Document Centredevice, perform the procedure contained in this documententitled How to Connect to Ethernet / Token RingNetworks.2. For Dynamic TCP/IP addressing refer to the section entitledDynamic/Static IP Addresses and WINS.3. Review the Table of Contents in this document. Find thenetwork operating system (NOS) or protocol, which pertainsto your network.4. Go to the page indicated and perform the procedure(s).5. Once you are finished it is recommended you print a test page.6. Check the print job for print quality. If print quality problemsexist, use the Problem Solving section of the ReferenceGuide to correct the problem.7. If your print job DID NOT print, see the Troubleshootingsection for your operating system in this document to correctthe problem.8. Once your Document Centre is installed and printing, you canrepeat these steps to enable your printer to print withadditional protocols or network operating systems.NOTE For detailed safety information about this product refer to theDocument Centre Reference Guide.