Printer components and options3-12 Installation Planning GuideSoftware, firmware, hardware, and paper requirementsThe optional bypass transport requires the following:• Dual stacker output module• Standard white, colored, predrilled, or preprinted paper.To minimize paper jams and misfeeds, use 20 pound or 80gsm (grams per square meter) bond xerographic grade.Xerox 4024 Dual Purpose Paper and Xerox 10 Series DualPurpose paper are optimal. Use paper with less than 6%moisture content so that the paper will not curl and jam.NOTE: The time between sheets exiting the bypass transport for8.5 by 11-inch / 216 by 279 mm paper, A4 paper, and 8.5 by 14-inch / 216 by 352 mm paper is 492 milliseconds in simplex modeand 1052 milliseconds in duplex mode. All times are measuredbetween the trail edge of the exiting sheet and the lead edge ofthe next entering sheet.Operator tasks for the bypass transportTo use the bypass transport and third-party finishing devices, youmust perform several tasks:• Install and remove the bypass transport.• Set up DFA personality profiles to provide the NPS/IPS withinformation about each finishing device.• Prepare the finishing device hardware necessary to finish theprinted output and inform the NPS/IPS of device names andparameters.• Enter appropriate commands at the printer controller toinitiate finisher jobs.• Clear paper jams in the bypass transport.You learn how to install and remove the bypass transport andclear jams in the operator training that is provided by Xeroxfollowing installation of the bypass transport.In addition, you must know how to prepare the third-partyfinishing device to process printed output. Obtain this informationfrom your third-party supplier.
