Xerox 6030 Release Note

Also see for 721: User guide Operator's manual Setup guide User guide Release note

Contents

Xerox 6030 Release Note Manual pdf 14 page image

8 Release NotesThe following information supplements the 12.0 customer user guides.8.1 6204 Specific8.1.1 Copying ARCH-E size printsTo maximize copying of ARCH-E size prints always copy them using the preset output formatARCH-E. When copied in synchro mode it is likely that ARCH-E documents will scan as1220mm and will incur unneeded pauses between printing pages. The 6204 IOT will pausebetween pages which are greater than ARCH-E (48 inches 1219 mm) in length for the fuser tocome all the way back to full temp even if it is in the nominal fuser temperature range.8.2 Controller8.2.1 Stamp does not appearIf the user tries to upload a stamp files that contains an invalid format, or if the Accounting Modeis set to “Enabled”, no error message will be displayed. The WebPMT screen will display amessage that the file was uploaded successfully and the stamp’s filename will not appear in the“Printer Resident Stamps” list. To avoid this situation, set the Job Accounting mode to “Optional”before uploading stamps. The WebPMT has no knowledge of the validity of any file that is sent tothe printer. File validation and error handling is done on the printer by the FreeFlow Accxescontroller. The WebPMT only reports that the file was sent to the printer successfully.8.2.2 Scaling interaction with “ANY”The media size “ANY” will select the best sheet size for an image to prevent clipping. If a userspecifies a media size of “ANY” and a scale factor that makes the image too large for any sheetsize and mismatch mode is set to scale, the controller will select the largest sheet size and scalethe image to fit on it.If this is not the desired behavior, a specific sheet size can be selected, or the media mismatchmode can be set to QUERY.8.2.3 Margins may cause image clippingIf the margins (TOP, BOTTOM, RIGHT and LEFT) are set to a non-zero value (5mm is thedefault) then that amount of whitespace will be added to the image before placing it on the mediaand could cause part of the image to be shifted off the page, or clipped. To correct this problemset the margins to 0.8.2.4 CGM Files and foldingCertain CGM files contain rotation commands which can confuse the system when folding. If thetitleblock is not visible or the plot is bypassed and not folded, change the titleblock location toobtain a correctly folded document.Page 14