8.5.3 Large Scaling FactorsImages set to scale beyond the largest installed roll will not scale beyond the largest width unlessa specific roll is selected, a specific page size is selected, or mismatch mode is set to somethingother than scaling. This is a behavior that has changed from previous releases (prior to 9.0).For example: The largest roll installed is 36". Scaling is set to 999%. Submit an ARCH E sizeddrawing (Media Size = Any, Mismatch = Scaling). The drawing will not be scaled.In order for the output to exhibit the desired scaling factor, one of the following conditions must bemet:What to do:• Set Mismatch Mode to Substitute• Request a Media Size of ARCH E via WebPMT, ACT, or the Driver• Request a Media Size 36" Roll via WebPMT, ACT, or the Driver8.5.4 HPGL Page – End of FileIf the files are streamed via any port on the system, these are treated as a single job and no resetis done between them. However, if one uses the LPD protocol to send the files one at a time, theeffect is that the printer is reset after each job. If the “Reinitialize after EOF” is set to be on, theFreeFlow Accxes firmware will reset the printing parameters after each plot file that is received bya serial port or a parallel port. To reset the HPGL parameters on the WebPMT, select PrinterDefaults > Emulations > HPGL. Click on the box in front of “Reinitialize after EOF”. Click on the“UPDATE PRINTER” button.8.5.5 Display of Media UsageThe WebPMT Linear Media Usage displays the Media Usage in METERS. The mechanicalmeters used on the Xerox Wide Format Print System 721p IOTs can be programmed using theIOT diagnostics and are determined by which mode (ANSI or ISO) that the IOT is programmed tooperate in. The units of measurement may not be the same.Both the WebPMT and Test print display Linear Media Usage as zero (0) for the 6030 and 6050printers. This is caused by a limitation in the interface between the FreeFlow Accxes controllerand the printer. The linear media information is available from the web page of the printer itselfon the status screen.8.5.6 Default PostScript Page SizeIf a PostScript job does not specify a page size (either by using a compatibility operator such as“letter”, or “a4”, or by using the setpagedevice operator /PageSize parameter), the page sizeused is the one specified by the Default PostScript Page Size parameter available via the printeruser interface, or via the WebPMT.8.5.7 “Printer has been updated” messageIf the user presses the “UPDATE PRINTER” button without actually making changes first, theWebPMT will still return a message that the printer was updated. The WebPMT cannotdistinguish a page that has been modified from one that has not been modified. This is becauseof the “stateless” nature of the http protocol and the fact that no events are generated (html)when text values are entered or items are selected. When the “UPDATE PRINTER” button ispressed, all the data on the form is gathered and sent to the server. If the data is valid, theprinter is updated and “The printer was updated successfully.” message is returned. IfPage 17