Xerox 850DP - Phaser Color Solid Ink Printer Manual

Also see for 850DP - Phaser Color Solid Ink Printer: Specifications Operator's manual Operator's manual System introduction Operator's manual

Contents

Xerox 850DP - Phaser Color Solid Ink Printer Manual Manual pdf 105 page image

Version 10.0Page 100 of 160AccXES PJL Interface5.1.8.1.1 ENGINELANG1/ENGINELANG2Some marking engines such as the Xerox 8830 support menu structures and other user messages onthe printer’s front panel in addition to those provided by the controller for the print engine. These twoparameters store the primary and secondary languages that the marking engine is capable ofsupporting. This variable takes on the same values as in the LANG parameter of the Printer Group.5.1.8.1.2 ENGINESTATEThe state of the marking engine is stored in this variable. It takes on one of the following values: {IDLE, PRINTING, ERROR, WARMING, INIT, LINK DOWN}. The ERROR state take precedence over thePRINTING state; if the marking engine is in the middle of a print job and jams, the marking enginewill move to an ERROR state, even though the print operation has not yet completed.The lINK DOWN state only applies to remote printers like the 6030 and 6050 where the AccXESController is acting like a Print Server.5.1.8.1.3 ENGINEMAXPLOTLENGTHThe maximum plot length that is supported by the marking engine is stored in this variable. Note thatsome of the marking engines supported by AccXES report this value at run-time based upon the IOTconfiguration.5.1.8.1.4 FINISHERSTATEThe state of the finisher is stored in this variable. It takes on one of the following values: {READY,ERROR, BYPASS}. The ERROR state indicates some condition that should be cleared before foldingoperations can proceed. The BYPASS state indicates that …5.1.8.2 Media GroupThe media status of the printer is detailed in this group. This includes the toner levels, the number andtype of trays and rolls in the printer, and the size and type of the media loaded.5.1.8.2.1 COLORANTELEMENTUSEDThese variables indicate the percent of a cartridges print elements (i.e. print head) used. The valuesrange from 0 to 100. Valid values for “n” are 1 to 4.5.1.8.2.2 COLORANTTYPEThis collection encodes the colorant type currently installed in the printers cartridge “n”, where “n” mayrange from 1 to 4. The possible values are: {CARTRIDGE_ABSENT, CARTRIDGE_BLACK,ARTRIDGE_CYAN, CARTRIDGE_MAGENTA,CARTRIDGE_YELLOW}.5.1.8.2.3 COLORANTUSEDThese variables specify the percent of cartridge number “n”, s colorant (ink, toner, etc.) used. The validrange for “n” is 1 to 4. The variable value may range from 0 to 100.5.1.8.2.4 INTRAYSIZEThis collection encodes the size of the paper currently loaded in tray “n” in the printer. See the PAPERenvironment variable in the Job Processing Group for a list of valid sizes which this variable can take.