6. Reinstall the cartridge unit to its original position in the finisher.7. Close the right cover on the finisher.NoteA message will display and the machine will not operate if the right cover is openeven slightly.Standard Finisher Plus fault codesFinisher Module fault codesIf an error code appears that is not listed in the table below, or if an error persists afterfollowing the listed solution, then contact your Xerox Customer Support Center.013-108Cause: The transport in sensor in the Finishing Transport did not switch ON within aspecified amount of time.Remedy: Perform the following:• Check for any obstructions or paper jams in the Finishing Module and FinishingTransport paper paths and clear them.• If necessary, power Off/On the machine, and if necessary, resend/restart your printjob.• If the fault persists, contact the Customer Support Center.013-109Cause: The transport exit sensor in the Finishing Transport did not switch ON withina specified amount of time.Remedy: Perform the following:• Check for any obstructions or paper jams in the Finishing Module and FinishingTransport paper paths and clear them.• If necessary, power Off/On the machine, and if necessary, resend/restart your printjob.• If the fault persists, contact the Customer Support Center.18-37Xerox® D110/D125/D136 PrinterUser GuideStandard Finisher Plus
