6.4 Using E-mail159Managing the Printer by E-mail (Status Messenger)66.4.1 Sending E-mail to the PrinterTo send e-mail to the printer, first specify the address of the printer in the address boxof e-mail program that you are using.The title of your e-mail is not important. Give the e-mail any title you like.The table below shows commands contained in the e-mail.Procedures for sending mail vary depending on your e-mail program. For details, refer to thedocuments provided with your e-mail program.CommandExamples of e-mail commandsThe following rules apply to e-mail commands: Each command must start with # and the e-mail must have the #Passwordcommand at the beginning. Commands that do not start with # are invalid. There can only be 1 command per line in the e-mail. The command and parametermust be separated by a space or tab. If the e-mail contains the same command more than once, only the first command isused. Others are ignored.Examples of e-mail commands are shown below.Example 1: Checking the printer status with the read-only password, ronly.Command Parameter Description#Password password When read-only or full-access passwords are set,be sure to write this command at the head. If nopassword is set, you can skip this step.#NetworkInfo - Specify this to confirm information with thenetwork settings list.#Status - Specify this to confirm the printer status.#setmsgaddr Trap destination e-mail addressUse this to set the trap destination e-mail address.This is only available when you specify the full-access password as the #Password command.#Password ronly#Status
