79Configuring in SMB Environment33.3 Changing the Host Nameand Workgroup NameIf necessary, change the SMB host name and workgroup name. Host Name: Factory setting is FXnnnnnn ("nnnnnn" is the last six digits ofthe Ethernet address set for the network card) Work Group Name: Factory setting is WORKGROUP.These items cannot be set at the control panel. If there is a need to change theseitems, do so from the CentreWare Internet Services or the Windows client.This section explains the procedure to change from the Windows client. From CentreWare Internet Services or the Windows client, you can change not only the hostname and workgroup name, but also other SMB environment settings. CentreWare Internet Services is available in TCP/IP environment and can be used when theprinter has been set with an IP address."Chapter 5 Using CentreWare Internet Services" or the online Help files of CentreWareInternet Services for information on CentreWare Internet Services3.3.1 Changing from the Windows ClientWhen changing host name or workgroup name from the client computer, you canaccess files of the printer through the Windows network. As such, SMB settings can bechanged by overwriting the contents in the files of the printer. However, you will need tohave the administrator name and password to change the settings using this method.The factory settings of the administrator name and password are listed below. For bettersecurity management, change the settings as early as possible. Use the Windows client or theCentreWare Internet Services to make these changes. Administrator name: admin Password: adminThe procedure is as follows. Here, we will use Windows 98 as an example.Procedure1 Switch on the computer and activate Windows 98.2 Double-click the Network Neighborhood icon.3 From the Network Neighborhood list, double-click the SMB workgroup(Factory setting: WORKGROUP) and then the icon with the host name.
