5.3 List of Menu Items1185Control PanelThe table below describes the situations when the printer is released from the power saver modes. Bydefault, "Power Saver Mode 2" is "Disabled". The printer does not switch to power saver mode 2unless you set it to do so.When an optional network expansion card is installed, the printer will not switch to power saver mode2. Mode 1 (default: 3 minutes)Set a time between 1 and 120 minutes. The printer automatically goes into power saver mode 1when it is idle for the duration set here. Mode 2 (default: 5 minutes)Set a time between 5 and 120 minutes. The printer automatically goes into power saver mode 2 afterbeing in power saver mode 1 for the duration set here."Mode 2" is not displayed when an optional network expansion card is installed.Power SaverSet this for each mode to determine if the printer goes into power saver mode.The printer does not go into power saver mode when it is "Disabled". Mode 1 (default: Enabled) Mode 2 (default: Disabled)"Mode 2" is not displayed when an optional network expansion card is installed.Release from power saver mode 1 Release from power saver mode 2(When the optional network expansion card is not installed) When receiving print data. When printing a report or list with "4:Report/List". When the menu screen is quit When pressing the Power saver button on the controlpanel. When receiving print data via the network. When accessing the printer via the network. When accessing the printer via the network utility. When searching for the printer with CentreWare InternetServices. When accessing the printer with CentreWare SimpleStatus Notification. When the computer accesses the printer via the network.