1.2 Configuring the Printer16Printer System Settings11.2.4 Setting the ProtocolsWhen the printer is shipped from the factory, all protocols except SMTP/POP3 ("Status Messenger","E-Mail Printing") and "FTP" are "Enabled" by default. You do not need to perform the operationsdescribed in this section when you connect a new printer to a network for the first time.This concludes the Printer Settings list. Move on to "1.2.5 Checking Settings".When you want to use the printer as a network printer, you need to set the rightprotocols on the printer. For TCP/IP(LPD) → "LPD" protocol For Port 9100 → "Port9100" protocol For IPP → "IPP" protocol For SMB (transport protocol: TCP/IP) → "SMB TCP/IP" protocol For SMB (transport protocol: NetBEUI) → "SMB NetBEUI" protocol For NetWare → "NetWare" protocolFollow the procedure below.When you want the printer to send and receive e-mail, start the "Status Messenger" and "E-MailPrinting" protocol in the same way.The procedure is described using screen examples with the optional network expansion card installed.If you do not have an optional network expansion card, the following protocols do not appear: SMB TCP/IP SMB NetBEUI NetWareRefer to "5.2 Basic Menu Operation" and "Appendix B Control Panel Menu List" for informationabout the operation of the control panel.
