4.2 Loading Paper 858. Push the tray all the way into the printer.If the tray is extended, the extended portionsticks out from the back of the printer.Important• When inserting the tray, be careful not to get yourfingers caught between the tray and the printer orother tray (if the optional sheet feeders are installed).Paper Sizes/ Paper Types of the Trays 1 - 4If you load standard-size paper in the trays 1 - 4, the printer automatically senses the sizeand orientation of the paper in each paper tray. If you loaded non-standard-size paper intothe tray 1, 2, 3, or 4, manually set its paper size on the control panel.The printer does not have ability to sense the type of the paper loaded in each paper tray.The default paper types for the trays 1 - 4 are [Plain Paper]. If you loaded paper other thanplain paper into the tray 1, 2, 3, or 4, manually change its paper type on the control panel.Make sure to set the paper type correctly on the control panel. If the paper type setting doesnot match the actual type of the paper, toner may not fuse properly onto the paper, resultingin poor print quality.Note• The paper type setting can be changed under [Paper Type] on the control panel. You can also changethe paper type from your print driver when requesting a print job.• You can program your printer to display a message asking you to change the paper type each time youload paper into the paper trays. You can program this under [Display Screen] on the control panel.Refer to• For information on how to set a paper size on the control panel, refer to " [Paper Size]" (P. 123).• For information on how to change the paper type on the control panel, refer to " Changing the PaperTypes of the Trays 1 - 4" (P. 86).• For information about [Display Screen], refer to " [Display Screen]" (P. 120).• For information on how to set a paper type on your print driver, refer to " Printing by Changing the PaperType Setting" (P. 55).Extending the Extension Output TrayThe extension output tray prevents printedoutput from falling off the printer.When printing documents, extend the extensionoutput tray.If the tray is not long enough, extend it all the way(the tray extends in two stages).
