Safety- 125 -Operation Setting up yourmachineGetting startedDirectoryMaintenanceSafety ContentsInstallationDate en cours : 11 août 2004\\Sct01002\BE31-DOC\DOC 31 - En cours\Travaux en cours\Fax\MFL V 2\LU 251 523 984B MFL_V2 FAXCENTRE F116_F116L XEROXFR_GB_ESP\Anglais\Sécurité.fmWARNING - E LECTRICAL S AFETY I NFORMATION• Use only power cord supplied with this equipment.• Plug the power cord directly into a grounded electrical outlet. Do not use an extension cord.If you do not know whether or not an outlet is grounded, consult a qualified electrician.• This equipment is to be used on an appropriate branch circuit. If this machine needs to bemoved to a different location, contact a Xerox service representative or your authorizedlocal representative or service support organization.• Improper connection of the equipment-grounding conductor can result in electrical shock.• Do not place this equipment where people might step on or trip on the power cord. Do notplace objects on the power cord.• Do not override or disable electrical or mechanical interlocks.• Do not obstruct the ventilation openings.• Never push objects of any kind into slots or openings on this equipment- If any of the following conditions occur, switch off the power to the machine immediatelyand disconnect the power cord from the electrical outlet. Call an authorized local servicerepresentative to correct the problem.- The equipment emits unusual noise or odors.- The power cord is damaged or frayed.- A wall panel circuit breaker, fuse, or other safety device has been tripped.- Liquid is spilled into the copier/machine.- The equipment is exposed to water.- Any part of the equipment is damaged.Disconnect DeviceThe power cable is the disconnect device for this equipment. It is attached to the back of themachine as a plug-in device. To remove all electrical power from the equipment, disconnect thepower cable from the electrical outlet.MFL 251 523 984_ FAXCENTRE F116_F116 L US.book Page 125 Mercredi, 11. août 2004 4:48 16