Xerox Nuvera 100 Hints And Tips Manual

Also see for Nuvera 100: System guide Getting started Install guide Software guide Planning guide

Contents

Xerox Nuvera 100 Hints And Tips Manual Manual pdf 14 page image

Release Issues Xerox NuveraCQ#38117 Short Edge Feed 9x11 StockDescription9 x 11 stock cannot be loaded short edge first (SEF).WorkaroundLoad an SEF-only stock such as Legal, run one or more sheets on that stock, then unload it andput in 9x11 SCQ#26871 Queue and Job based subsetting fails for Oddnumber of pages duplex jobsDescriptionSubset offset and finishing can be programmed on job in the job manager or on a Queue. Thisworks fine for simplex jobs. It will also work for duplex jobs as long as the request is for aneven number of images. But if the request is for a subset that would require a duplex page tobe split then the request fails.WorkaroundOnly program even number of pages in the subset.CQ#47602 DS3500 finisher: a Job integrity issue may occur ifthe unload button is pressed just before the first sheet isdeliveredDescriptionIF the user presses the DS3500 stacker unload button just before the first sheet of the jobreaches the stacker, there may be a jam in the flipping wheel area which could cause jobintegrity issues.WorkaroundPlease do not press the DS3500 stacker unload button just before receiving the first sheet of ajobCQ#47579 Non-clearable Top Edge Sensor FaultDescriptionIf a Top Edge Sensor fault occurs and the machine is restarted with the IOT doors open, a non-clearable Top Edge Sensor Fault may occur.WorkaroundClose the IOT doors and then Power-off/Power-on the machine and the fault will clear. Toavoid the occurrence, ensure the IOT doors are closed before restarting the machine.3-4 Hints and Tips Guide