Solving Print-Quality ProblemsPhaser® 4510 Laser Printer4-17Print Area Is Not Centered on the PaperThe printed area appears outside the margins on the page. Use the following procedure to resetthe margins.1. On the control panel, select Paper Tray Setup, and then press the OK button.2. Select the tray you are using, and then press the OK button.3. Verify that the tray is set to the correct paper size.4. If the problem continues, use the Calibrate Margins page to shift the print area on thepaper. The print area appears as a dashed rectangle on the Calibrate Margins page; theprinter does not print outside this rectangle.a. On the control panel, select Troubleshooting, and then press the OK button.b. Select Print Quality Problems, and then press the OK button.c. Select Calibrate Margins, and then press the OK button.d. Select Calibrate Margins Page, and then press the OK button.e. Select the appropriate tray to calibrate, and then press the OK button.f. Follow the instructions on the Calibrate Margins page.Note: The leading edge margin specification is 4 mm ± 2 mm. The side edge marginspecification is 4 mm ± 2.5 mmDownloaded From ManualsPrinter.com Manuals
