Xerox Synergix 8825 Software Manual

Also see for Synergix 8825: User guide Setup guide User guide Release note System introduction

Xerox Synergix 8825 Software Manual Manual pdf 17 page image

XES Synergix 8825/8830/8850/8855 Windows NT 4.0 PostScript Print Driver User Guide 13Document Properties Dialog (Advanced Tab Parameters)Copy CountThis parameter displays the currently-selected number of copies to print.To change the Copy Count, left mouse click on Copy Count and enter aselection from 1 to 999 in the entry box supplied in the bottom dialog box.Note that although the driver supports 9999 copies, the printer isrestricted to a maximum count of 999. The default copy count is 1.Collate CopiesWhen you select Copy Count and make an entry of more than 1, theCollate Copies check box is enabled at the bottom of the dialog. Ifyou would like to have copies printed out in 1-2-3, 1-2-3 order(depending upon your application), use your left mouse button toplace a check mark in the Collate Copies box. The default forcollation is off.GRAPHIC PARAMETERSColor AppearanceAs the printer is a Monochrome device, the setting for Color Appearanceis not important. If Monochrome is not the default, you may click onColor Appearance and select the Monochrome radio button at the bottomof the dialog.ScalingThis parameter displays the currently-selected Scaling of the printedimage. To change the scaling, left mouse click on Scaling and enter aselection from 10 - 999%, which is the scaling range supported by theprinter. The default setting is 100%.Note: If you are performing a large scale enlargement, be sure tomanually select the appropriate Paper Size so that your image will fit ontoone of the available rolls of media installed in the printer.TrueType FontThis parameter displays the currently-selected option for printing withTrueType Fonts. To change the selection, left mouse click on TrueTypeFont and click on the appropriate radio button. If you would like to printwith the TrueType fonts exactly as shown on your screen, selectDownload as Soft font. If you prefer substituting printer-residentPostScript fonts for your TrueType fonts, speeding up the printingprocess, select Substitute with Device Font. The default is Substitutewith Device Font.Tip: To quickly view your system-installed fonts and the printer-residentfonts currently selected for substitution, go to ìStart,î ìSettingsî,ìPrinters,î right mouse click on your PostScript printer icon, selectìProperties,î and click on the Device Settings Tab. Double click on FontSubstitution Table. To see a display of printer-resident fonts available forsubstitution, click on any font and a list will be displayed at the bottom ofthe dialog.