Xerox Synergix 8825 Software Manual

Also see for Synergix 8825: User guide Setup guide User guide Release note System introduction

Xerox Synergix 8825 Software Manual Manual pdf 5 page image

XES Synergix 8825/8830/8850/8855 Windows NT 4.0 PostScript Print Driver User Guide 1IntroductionPurpose of this GuideThe purpose of this Guide is to assist you with instructions for installing aPostScript Print Driver, adjusting the Print Driverís settings to meet yourneeds, printing with the Print Driver, and removing the driver when it is nolonger needed.Electronic copies of this Guide are available on the Internet at www.xes.com.Basic RequirementsA Workstation running Windows NT 4.0 with Service Pack 3, or higher,installed.A Working Knowledge of your Workstationís Operating System.Appropriate Cabling connecting your workstation to the network or directlyto the printer's AccXES Controller.Appropriate protocols and ports enabled on both the printer andworkstation, with a connection established through the network or directlybetween the printer and your workstation.How to Use this Guide1. Read ìBefore You Startî for valuable information on checking thestatus of your communication protocols and creating a new printer portfor use with the PostScript Driver.2. Install the driver on your workstation as stated in the DriverInstallation section of this Guide.3. Configure the driver settings to meet your needs as stated in theDriver Configuration section of this Guide.4. Click OK on the Print Screen to print your job.5. If you no longer need the driver, remove the driver as stated in theRemoving the Driver section of this Guide.