Operation5-3) Using the keys or or the numerical key pad select the required base values andconfirm with the OK key.) Using the keys or select the type of paper NORMAL PAPER or THICK and confirmwith the OK key.) Using the keys or select the required paper tray, AUTOMATIC TRAY, UPPER TRAYor LOWER TRAY and confirm with the OK key.S PECIFIC COPY SETTINGSWhen the copy quality is no longer satisfactory, you can perform a calibration. To do so, refer toparagraph Scanner calibration, page 6-17.Moreover, a high number of controls let you improve the copy quality.Scanner settings841 OK - ADVANCED FCT / COPY / RESOLUTION) The Resolution parameter adjusts the photocopying resolution. Select High Speed, Qualityor Photo resolution using keys or , then validate the choice with the OK key.842 OK - ADVANCED FCT / COPY / ZOOMING) The zoom setting is used to reduce or enlarge part of the document by choosing the originaland the zoom value to apply to the document, 25 to 400 %. Enter the zoom value requiredusing the keys of the digital key pad. Validate the choice with the OK key.843 OK - ADVANCED FCT / COPY / ASSEMBLED) The ASSEMBLED parameter is used to define the choice of your printer outputs; eitherassembled or not assembled. Validate the choice with the OK key.844 OK - ADVANCED FCT / COPY / ORIGINIf you wish, you can change the origin of the scanner.By entering new values of X and Y given in mm (X < 210 and Y < 286), you will move thescanning zone as shown on the figure below.) Select the X and Y coordinates with keys or .scanned areaTop view: scanned side downyxTOP OF SHEETEND OF SHEET
