Xerox WorkCentre 4118 System Administration Manual

Also see for 4118P - WorkCentre B/W Laser: Installation guide Quick start card Brochure & specs Quick reference guide Quick guide

Contents

Xerox WorkCentre 4118 System Administration Manual Manual pdf 17 page image

Xerox WorkCentre 4118 System Administration Guide Page 2-5Basic Network InstallationBasic TCP/IP SettingsBefore the printer can be used on the network, the TCP/IP addresses needs to be entered.These can be entered automatically using Dynamic Host Configuration Protocol (DHCP) orBootstrap Protocol (BOOTP) or entered manually. To enter the addresses manually, you needto obtain the following:¾ TCP/IP Address¾ Gateway Address¾ Subnet Mask Address¾ Primary DNS Server AddressInstallation ProcedureThere are three stages required to install the WorkCentre 4118 in a TCP/IP networkingenvironment:¾ Network Communication SetupThis requires the WorkCentre 4118 to be setup for TCP/IP.¾ Workstation SetupThis requires the workstations in the networking environment to beconfigured to communicate with the WorkCentre 4118.¾ Test PrintA print job should be submitted to ensure the WorkCentre 4118 has beeninstalled and configured correctly.